1.Flush and clean up with water: Put special purified water in, open special pumps, and open drainage valves to discharge outwards until the resistivity value of water at each outlet point is the same as that of water in the tank, for the discharge time,it is better than 30 minutes.
2.Passivation: Use purified water and chemical pure nitric acid specially to match 8% of the acid solution, and circulate for 60 minutes at 49 – 52 °C. In other words, 3% hydrofluoric acid (volume), 20% nitric acid (volume fraction) and 77% purified water are matched by professionals. The temperature of the solution is controlled between 25 and 35 °C, and the treatment is repeated for about 10 to 20 minutes.
3.Start washing: rinse with purified water at normal temperature for no less than 5 minutes.
4.Rinse in one step: Then use the rinse until the resistivity of the purified water is the same as that of the newspaper at the inlet and outlet.
5.Pure steam professional disinfection: the very clean steam to this stainless steel pipeline control center, so that any device and surface can be cleaned for more than 15 minutes.
6.Different kinds of electrodes have different properties and characteristics in use. They are selected according to the corresponding needs in use to ensure the quality of welded stainless steel stamping elbows. In order to improve the corrosion resistance and weldability of stainless steel stamping elbow, appropriate amount of stability elements Ti, Nb, Mo etc. are added in production, and the weldability is better than that of chromium stainless steel stamping elbow. When the same type of chromium stainless steel stamping elbow is used, it should be preheated above 200℃ and tempered around 800 ℃after welding. If the weldment cannot be heat treated, the chromium-nickel stainless steel stamping elbow should be selected.
Post time: Jun-14-2022